Command
HDCP Output Mode (on TX, applies to both outputs simultaneously)
Set output HDCP mode all
outputs
View status
X(
KEY:
= HDCP output mode
1 = Encrypt as required by input. Continuous trials for HDMI sinks, attempt for 10s on DVI sinks (then fail). (Default)
2 = Always encrypt. Continuous trials for HDMI sinks, attempt for 10s on DVI sinks (then fail).
EDID (Tx only)
View input EDID in HEX format
View input EDID native rate
KEY:
X1!
= 128 or 256 Byte EDID raw HEX (text form) from currently assigned EDID.
X1@
= Native resolution and refresh rate from currently assigned EDID, for example: 1920x1080 @ 60 Hz.
Remote Send Power Switch
Send Power switch status
X@
KEY:
= Remote power
DTP/HDBT Switch
DTP/HDBT Switch Status
(Tx only)
X1$
KEY:
= DTP/HDBT switch status
5V Output Hot-plug Mode (only applies to HDMI output ports)
Set output hot‑plug mode (5V)
Output hot‑plug mode (5V)
status
X1#
=
5V output mode
KEY:
Verbose Mode
Set verbose mode
View verbose mode
X$
=
Verbose mode
KEY:
ASCII Command
Response
(host to unit)
(unit to host)
E
X(
}
S
HDCP
HdcpS
E
X(
}
SHDCP
HdcpS
Verbose mode 2/3
E
X1!
}
REDID
E
X1@
}
NEDID
E
X@
RPWR
}
Rpwr
Verbose mode 2/3
0 = Remote power disabled
E
X1$
}
OHDBT
HdbtO
Verbose mode 2/3
1 = DTP mode
E
X1#
M
HPLG
}
HplgM
E
X1#
MHPLG
}
Verbose mode 2/3
1 = Auto (5V enabled when source with 5V present, else off)
2 = 5V always enabled (default)
E X$
}
CV
Vrb
E
X$
CV
}
0 = Clear/none (default)
1 = Verbose mode
3 = Verbose mode and tagged responses for queries
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control
X(
]
]
X(
]
]
]
]
X@
]
1 = Remote power (48 VDC) enabled
]
X1$
]
2 = HDBT mode.
X1#
]
]
X$
]
]
2 = Tagged responses for queries
Additional Description
Hex data from EDID
assigned to input.
Native rate of EDID
assigned to input.
20