Table of Contents
Advertisement
12.
13.
14.
After the transmitter, the receiver, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, ensure all cables are routed and
connected properly.
NOTE: Ensure the video source and display selected for the DDC are properly
Connections
Transmitter Rear Panel Connections
POWER
12V
0.8A MAX
A
A
Figure 2.
A
In a DTP2 transmitter to DTP2 receiver configuration, set the SEND POWER
toggle switch to the
position on the powered DTP2 device to enable sending
UP
remote power to the far end DTP2 device. Set the toggle switch to the
the DTP2 device receiving power (see figure 8,
ATTENTION:
•
The DTP2 211 device is configured to output power to DTP2 models only. If
connected to a Legacy DTP device, set the toggle switch to the
position. Failure to turn the power OFF will damage the connected Legacy DTP
device.
Le DTP2 211 est configuré pour fournir une alimentation aux modèles
•
DTP2 uniquement. S'il est connecté à un autre appareil, veuillez positionner
l'interrupteur à bascule sur «
sur OFF, vous risquez d'entraîner la défaillance de l'appareil Legacy DTP
connecté.
Connect power to the transmitter or receiver.
Power on the source devices.
connected to the transmitter and receiver pair, and the transmitter, receiver, and display
have power applied before power is applied to the video source. If the other devices
are not turned on before the video source, the image may not appear.
INPUTS
SIG
LINK
AUDIO
DTP2 OUT
B
B
C
C
D
D
DTP2 T 211 Transmitter Connectors
Power inlet — Plug the included external 12 VDC power supply into either this 2-pole
inlet or the power inlet on the receiver (see figure 3,
Supply Wiring
on page 12 to wire the connector).
NOTES:
•
One power supply is included with the transmitter and can normally power
both units. Remote power is only available if both the transmitter and the
receiver are from the Extron DTP2 series.
•
The power supply can be plugged into either the transmitter or the receiver to
power both units.
•
If the internal jumper setting for ground is removed, a DTP2 211 unit cannot
remotely power the other unit, because of ground potential differences. Each
unit requires a local power supply (see
on page 15).
D
» (OFF). Si l'interrupteur n'est pas positionné
DOWN
Power inlet
A
OVER DTP2
Audio input
B
RS-232
IR
HDMI input
C
Tx Rx
G
Tx Rx
DTP2 Output RJ-45 port
D
E
E
Over DTP2 RS-232 and IR port
E
, on page 8, and
A
Internal Settings
DTP2 T/R 211 • Installation and Operation
position on
DOWN
(OFF)
DOWN
Power
on page 32).
6
Advertisement
Table of Contents
