Connections; Transmitter Rear Panel Connections - Extron electronics DTP3 T 202 User Manual

11.
DTP3 T 202 Front Panel
12.
13.
After the transmitter, the receiver, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, ensure all cables are routed and
connected properly.

Connections

Transmitter Rear Panel Connections

DTP3 T 202 Rear Panel
Figure 2.
A
B
C
In a DTP3 transmitter to DTP3 receiver configuration, set the SEND POWER
toggle switch to the UP position on the powered DTP3 device to enable sending
remote power to the far end DTP3 device. Set the toggle switch to the DOWN position on
the DTP3 device receiving power (see figure 8,
ATTENTION:
• The DTP3 T 202 and DTP3 R 201 devices are configured to output power to
DTP3 models only. If connected to a non-DTP3 device, set the toggle switch
to the DOWN (OFF) position. Failure to turn the power OFF will damage the
connected device.
• Le DTP3 T 202 et le DTP3 R 201 sont configurés pour alimenter uniquement
les modèles DTP3. S'ils sont connectés à un autre type d'appareil, veuillez
positionner l'interrupteur à bascule sur « DOWN » (OFF). Si l'interrupteur n'est
pas positionné sur OFF, vous risquez d'entraîner la défaillance de l'appareil non
DTP3 connecté.
Connect power to the designated "powered DTP3 device".
SEND
PWR
Power on the source devices.
CONFIG
e
OFF
A B C
SIG
POWER HDMI HDMI
12V
--A MAX
LOOP OUT INPUT
A B C
DTP3 T 202 Transmitter Connectors
Power inlet — Plug the included external 12 VDC power supply into either this 2-pole
inlet or the power inlet on the receiver (see figure 3,
Supply Wiring on page 9 to wire the connector).
NOTES:
• One power supply is included with the transmitter and can normally power
both units. Remote power is only available if both the transmitter and the
receiver are from the Extron DTP3 series.
• The power supply can be plugged into either the transmitter or the receiver to
power both units.
Loop Out — Passes the original HDMI video signal out, unaltered, to another device.
HDMI input — Connect an HDMI cable between this port and the digital video source.
Securing the HDMI Connector
NOTE: See
HDMI connectors to the transmitter and the receiver.
).
D
HDBT INPUT
SIGNAL
HDCP
DTP DTP3 T 202
D E
LINK
OVER
TP
RS-232
Tx Rx G
OUT
D E
A
on page 8 to securely fasten the
DTP3 T 202 / DTP3 R 201 • Installation and Operation
DTP3 R 201 Front Panel
CONFIG
e
A B
DTP3 R 201 Rear Panel
Power inlet
A
POWER HDMI
12V
Loop Out
B
--A MAX
HDMI input
C
OUTPUT
Output RJ-45 port
D
Over TP RS-232 port
E
A B
on page 6, and Power
SEND
DTP
PWR
SIGNAL
HDCP
OFF
D
C D
SIG LINK
OVER
L
DTP3
RS-232
Tx Rx G A
DTP3 IN
C D
5