Resetting - Extron electronics DTP3 T 202 User Manual

4. Select Install the software automatically (Recommended) radio button (see
figure
5.
Click Next (
NOTE: You do not need to insert an installation disc.
The PC locates the driver needed and installs it in the correct location on the hard drive.
6. When the
NOTE: The wizard opens only on the first occasion you connect the transmitter
or receiver to that USB port. The wizard reappears if you connect the unit to a
different USB port or if you connect a different piece of equipment, requiring a
different driver, to the same USB port.
7. Configure the transmitter or receiver as required using SIS Commands (see
Configuration and Control

Resetting

Use the SIS command to reset the transmitter or receiver to its factory default settings (see
Reset on page 22).
12, ).
1
).
2
screen appears, click Finish to close the wizard.
Completed
starting on page 16).
DTP3 T 202 / DTP3 R 201 • Installation and Operation
SIS
15