Securing The Hdmi Connector; Tp Cable Termination And Recommendations - Extron electronics DTP3 T 202 User Manual

Securing the HDMI Connector

Follow these instructions to secure the input and output connectors to the transmitter and
receiver with the LockIt HDMI lacing bracket provided:
Plug the HDMI cable into the rear panel connection.
1
Loosen the HDMI connection mounting screw from
2
the rear panel enough to allow the LockIt lacing
bracket to be placed over it. The screw does not
have to be removed.
Place the LockIt lacing bracket on the screw and
3
against the HDMI connector, then tighten the screw
to secure the bracket.
ATTENTION:
•
•
Loosely place the included tie wrap around the
4
HDMI connector and the LockIt lacing bracket as
shown.
While holding the connector securely against the lacing bracket, tighten the tie wrap,
5
then remove any excess length.

TP Cable Termination and Recommendations

The TIA/EIA T 568B wiring standard is detailed in figure 5. Use this standard to terminate
TP cables with RJ‑45 connectors.
Side
Figure 5.
ATTENTION:
Do not use Extron UTP23SF‑4 Enhanced Skew‑Free AV UTP cable or STP201
•
cable to link the XTP products or with DTP3 transmitters or receivers. The DTP3
devices do not work properly with these cables.
• N'utilisez pas le câble audiovisuel Skew‑Free UTP version améliorée UTP23SF‑4
Extron ou le câble STP201 pour relier les produits XTP à des émetteurs ou
récepteurs DTP3. Le DTP3 ne fonctionne pas correctement avec ces câbles.
Do not overtighten the HDMI connector
mounting screw. The shield it fastens to is
very thin and can easily be stripped.
Ne serrez pas trop la vis de montage du
connecteur HDMI. Le blindage auquel elle
est attachée est très fin et peut facilement
être dénudé.
Pins:
RJ-45
1 2 3 4 5 6 7 8
Connector
TIA/EIA T
568 B
Pin Wire color
White-orange
1
2 Orange
3
White-green
4 Blue
5 White-blue
6 Green
Insert
7 White-brown
Twisted
8 Brown
Pair Wires
TP Cable Termination
DTP3 T 202 / DTP3 R 201 • Installation and Operation
2 2 2
1 1 1
3 3 3
4 4 4
3
5 5 5
8