SIS Configuration
and Control
Use Simple Instruction Set (SIS) commands to configure the DTP3 T 202 transmitter and
DTP3 R 201 receiver. This section provides information about using those commands. The
following topics are discussed:
•
•
•
•
•
The DTP3 devices can be remotely configured and controlled using SIS commands or PCS.
via a host computer or other device (such as a control system) connected to the front panel
USB configuration port.
Host Control Port
The front panel USB C configuration port (see
to a host computer for configuration using SIS commands via an SSH client and IP address
203.0.113.22 on port 22023
Establishing a Connection
Establish a network connection to a DTP3 device as follows:
1.
2.
3.
4.
5.
Host Control Port
Simple Instruction Set Control
Symbols Used in this Guide
Command and Response Table for SIS Commands
Downloading and Updating Firmware
Download the SSH client software from the internet.
Open the SSH client software.
Enter the IP address of the DTP3 device in the Host Name or IP address field.
NOTE: If the local system administrators have not changed the value, the default IP
address is 203.0.113.22.
Enter 22023 in the Port field.
The DTP3 device is password protected, so the appropriate administrator or user name
and password must be entered.
If the login and password are correct, the device responds with a copyright
•
message including the copyright year, the name of the product, firmware version,
part number, and the current date and time.
If the login and password are incorrect, the Login as prompt returns. Enter the
•
administrator or user name and password again.
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control
figure
8,
, on page 13) can be connected
B
16