Simple Instruction Set Control; Host-To-Unit Instructions; Device-Initiated Power-Up Message; Error Messages - Extron electronics DTP3 T 202 User Manual

Simple Instruction Set Control

Host‑to‑Unit Instructions
SIS commands consist of strings (one or more characters per command field). Upper and
lower case characters can be used interchangeably. Commands do not require any special
characters to begin or end the command string. Each response from the transmitter and
receiver ends with a carriage return and a line feed (CR/LF =
the response character string.
Device‑initiated Power‑up Message
When the transmitter or receiver is first switched on, it sends the message:
(c) Copyright 2021, Extron Electronics DTP3 X 2xx, Vx.xx 60‑1869‑xx

Error Messages

E10
E13

Timeout

Pauses of 10 seconds or longer between command ASCII characters result in a timeout.
The command operation is aborted with no other indication.
NOTES:
•
The DTP3 devices are shipped password‑protected. The factory configured
passwords for all accounts on these devices have been set to the device serial
number.
• In the event of a complete system reset, the password converts to the default,
which is extron. New passwords must be configured to secure the device .
• password‑protected connections, there are two levels of protection:
On
administrator and user. Administrators have full access to all editing functions
is the device model.
DTP3 X 2xx
•
is the firmware version number.
• Vx.xx
is the part number of the device.
60‑1869‑xx
•
— Invalid command
— Invalid parameter
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control
]
), which signals the end of
]
17