Receiver Rear Panel Connections - Extron electronics DTP3 T 202 User Manual

DTP3 R 201 Front Panel
INPUT
AL
CP
DTP3 T 202
E A

Receiver Rear Panel Connections

DTP3 R 201 Rear Panel
OVER
TP
RS-232
Tx Rx G
E
Link LED — This amber LED indicates a valid link is established between the
•
transmitter and the receiving device.
ATTENTION:
• Do not connect these devices to a telecommunications or computer data
network. SEND
• Ne connectez pas ces appareils à un réseau de télécommunications ou de
CONFIG
e
données informatiques.
NOTE: See
B C
properly wire the RJ‑45 connectors.
Over TP port — Connect a serial RS‑232 signal to this 3.5 mm, 3‑pole captive screw
E
port for bidirectional RS‑232 communication (see
page 11 to wire the connector).
SIG
POWER HDMI
12V
--A MAX
OUTPUT DTP3 IN
A B
Figure 3. DTP3 R 201 Receiver Connectors
Power inlet — Plug the included external 12 VDC power supply into either this 2‑pole
A
inlet or the power inlet on the transmitter (see
Supply Wiring
NOTES:
• One power supply is included with the transmitter and can normally power
both units. Remote power is only available if both the transmitter and the
receiver are from the Extron DTP3 series.
• The power supply can be plugged into either the transmitter or the receiver to
power both units.
HDMI output — Connect a display with an HDMI input port (or DVI input port, with an
B
appropriate adapter) to display the transmitted digital image.
NOTE: See
the HDMI connectors to the transmitter and the receiver.
DTP3 In port — Connect one end of the TP cable from the transmitter output to
C
this RJ‑45 port. Ensure the opposite end of this cable is connected to the transmitter
Output port (see
Signal LED — This green LED indicates the unit is receiving a TMDS clock signal
•
valid signal on the DTP3 In port.
Link LED — This amber LED indicates a valid link is established between this
•
receiving device and the transmitter.
NOTE: See
properly wire the RJ‑45 connectors.
DTP
PWR
SIGNAL
HDCP
OFF
DTP3 R 201
TP Cable Termination and Recommendations
D
LINK
OVER
L R
DTP3
RS-232
Tx Rx G AUDIO OUT
C D E
on page 9 to wire the connector).
Securing the HDMI Connector
figure 2, , on page 5).
D
TP Cable Termination and Recommendations
DTP3 T 202 / DTP3 R 201 • Installation and Operation
on page 8 to
RS-232 Connector Wiring
Power inlet
A
HDMI output port
B
DTP3 In RJ-45 port
C
Over DTP3 RS-232 port
D
Audio output
E
figure 2,
, on page 5, and
A
on the next page to securely fasten
on page 8 to
on
Power
6