Extron electronics DTP3 T 202 User Manual page 36

12. If this is the only device uploading firmware, click Add (
added to the Device section of the Firmware Loader window and the Add Device
window closes.
If firmware is uploading to multiple devices, do the following:
a. Click Add Next (see
of the Firmware Loader window, and the Add Device... window remains open.
b. For each additional device that needs to be added to the Firmware Loader
window, repeat steps 4 through 9, then click Add Next(
c. For the last device, click Add (see
the device and close the Add Device... window.
To remove a device from the Device section, do the following:
13.
a. Click on the names of the devices to be deleted, highlight them (see figure 23,
1 1 1
DTP3 T 202 60-1869-52
Figure 23. Firmware Loader Screen with a DTP3 T 202 Added
b. Click on the Edit tab (see figure 24,
c. Select Remove Selected Device(s) (
1
2
3
Figure 24. Firmware Loader Edit Menu
d. Select Remove All Devices (
14.
Click Begin (see figure 23,
The following indicators show the progress of the update:
The Transfer Time section shows the remaining and elapsed time for the
•
update.
The Total Progress section displays a progress bar with Uploading...
•
above it.
In the Device section, the Progress column displays an incrementing
•
percentage and another progress bar.
The Status column displays Uploading....
•
figure 22, ). The first device is added to the Device section
2
figure 22,
3
1.00.001 dtp3t202_A_v1.00.00...
) in the menu bar at the top of the page.
1
) from the Edit menu.
2
) from the Edit menu to remove all devices.
3
).
2
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control
). The device name is
3
).
2
), instead of ( ), to add
Add Next 2
2 2 2
Extron USB Devi... Connected
).
1
28