Optex i-OneX T Quick Setup Manual

OPTEX i-OneX T Quick Setup Guide
For detailed information, please refer to the installation manual supplied with each sensor
and notes please refer to the i-OneX T Connection Matrix.
Sensor Mounting Location
Header
Use supplied Mounting Template.
Place template so that it is in the
center of the clear door opening
and so that the bottom of the tem-
plate is between 1/4" and 2" from
the bottom edge of the header.
Remove Cover
Remove the cover
Screw driver Cover locking
tabs
Dipswitch Settings
Dipswitch 3
Frequency
Dipswitch 4
Dipswitch 5 BLUEZONE™
Dipswitch 13 Direction
Dipswitch 14 Simultaneous output
Dipswitch 15 Safety Output (to door controller)
Dipswitch 16
Safety Input (from door controller)
Dipswitch 18 Installation Mode
Adjusting the Pattern Width
Left eliminated Right eliminated
1 2 3 7 8 9
Width adjustment screws
Align with center of clear door opening
2"
1/4"
Insert
1
Screw driver
Slide forward to
2
remove cover
Setting 1 Setting 2 Setting 3
3 4 3 4
OFF ON
5 5
Bi Uni
13 13
OFF ON
14 14
N.O. N.C.
15 15
High Low
16 16
OFF ON
18 18
1 2 3
Opens all
Opens all
elimination
areas areas
1 2 3 4 5 6 7 8 9
(continue other side)
Drill (2) 1/8" holes and (1) 5/16" hole as indi-
cated on the template. Remove template from
header. Remove the cover from the sensor.
Fasten the sensor securely to the header
using the supplied screws (do not over-torque
screws or sensor body may distort).
.
Setting 4
When using more than one sensor close to each other,
set the frequency different for each sensor
3 4 3 4
When dipswitch 5 is set to "ON", the BLUEZONE (1st row)
is active and looks through the threshold.
When dipswitch 13 is set to "Uni", this enables the door to
close faster when a person walks away from the door.
When dipswitch 14 is set to "ON", both the activation &
safety relay outputs will operate simultaneously regard-
less of detection area. But only the Safety ouput relay
will respond back with a Safety output when it receives a
Safety input.
Select "N.O."/"N.C." for Safety output.
The delay time between Safety input and Safety output is
10 msec.
Set dipswitch 18 to "ON" to adjust the 2nd row. During the
installation mode only the 2nd row remains active and the
operation indicator shows yellow. After setting the row, turn
dipswitch 18 "OFF".
The width of the Approach area can be adjusted
by changing Dipswitches 8-10 as shown below.
Dipswitches
7 8 9
elimination
1 2 3 4 5 6 7 8 9
8 9 10
1 2 3 4 5 6 7 8
1
2
3 6
4 5
Active area
Inactive area
8
7