DiGidot C4 Extended Manual page 55

Convert a pixel product into simple '1,2,3,' chaser for less control channels: Copy the input channels
1,2,3, in the following order the outputs.
Increase pixel size/ decrease channels: Combine/group multiple output channels into one, in order to
save input channels.
NOTE: Combining input channels will not reduce the amount of output channels.
The DiGidot C4 is always limited to the total amount of output channels corresponding to the
license. The number of input universes is not limited.
Gamma correction
Gamma correction adjust the overall brightness of the output. This option is used if you want to
display real looking videos instead of high saturated effects.
Color profile
Rearrange the LED color order, for example from RGB to BGR. You can select a few standard
conversion profiles or create your own Custom profile. This might be required for some LED
products. The DiGidot C4 uses the default color order from the technical documentation of a
selected IC/SPI protocol.
Fallback color
This function allows to select a color that will be send to all output channels as soon as no incoming
signal is detected.
Color
Enter an RGB(W) value between 0 and 255 per LED channel or use the color picker to select a
color easily. If you use the color picker, you can also adjust the saturation and brightness by
adjusting the sliders underneath. After selecting the fallback color, hit the ✓ button in the
center of the color picker to confirm your selection.
Timeout
Enter a delay/timeout in seconds when the fallback color becomes active after signal loss.
Advanced input
Further universe specific settings can be changed;
Only accept signal from IP Address: enter a dedicated IP address that this universe listens
‣
too.
C4 Manual Version 2.2.0 55-78