KidKraft CASTLEWOOD Installation And Operating Instructions Manual page 69

Step 32: Attach Elbow Assembly to Flange Assembly
Part 2
Note: When installing Pan Bolts make sure to look at holes so bolts
go through the side with the round recess and the lock nuts go
through the side with the hexagonal recess. Keep all bolts loose until
further step.
C: Attach 1 TNR2 Slide Clamp Ring to the bottom of the joined Assemblies
using 2 (PB1) Pan Bolts (with lock nut) on one side and 1 (PB1) Pan Bolt
(with lock nut) in the other side, making sure to match the arrows up with
the end of the clamp ring (where a seam will be) as shown in fig. 32.5, 32.6
and 32.7.
D: Connect the 2 TNR2 Slide Clamp Rings together in 2 spots using 1
(PB1) Pan Bolt (with lock nut) per hole. Make sure seams and arrows line
up and then tighten all bolts. (fig. 32.8 and 32.9).
Fig. 32.6
PB1
Fig. 32.8
PB1
Make sure
arrows are
aligned
LN1
5 x
LN1
Bottom Slide Bolt Holes
LN1
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
Hardware
Pan Bolt (lock nut)
PB1
69
Fig. 32.5
Fig. 32.7
(Side not shown)
DO NOT USE
USE IMAGE
PB1
Fig. 32.9
DO NOT USE
USE IMAGE
DO NOT USE
USE IMAGE
Other Parts
1 x TNR2 Slide Clamp Ring