KidKraft CASTLEWOOD Installation And Operating Instructions Manual page 71

DO NOT USE
DO NOT USE
USE IMAGE
Step 33: Attach Elbow Assembly to Elbow Assembly
USE IMAGE
Part 2
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the
round recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose
until further step.
C: Attach 1 TNR2 Slide Clamp Ring to the bottom of the joined Assemblies using 3 (PB1) Pan Bolts (with lock
nut), making sure to match the arrows up with the end of the clamp ring (where a seam will be) as shown in fig.
33.3 and 33.4.
D: Connect the 2 TNR2 Slide Clamp Rings together in 2 spots using 1 (PB1) Pan Bolt (with lock nut) per hole.
Make sure seams and arrows line up and then tighten all bolts. (fig. 33.3 and 33.5).
Fig. 33.4
Bottom Slide Bolt Holes
Elbow
Assembly
PB1
Hardware
5 x Pan Bolt (lock nut)
PB1
Elbow
Assembly
LN1
Fig. 33.5
71
Fig. 33.3
Make sure arrows
are aligned
PB1
LN1
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
Other Parts
1 x TNR2 Slide Clamp Ring