How To Install Inserts - Clock Assembly - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 13: How to Install Inserts - Clock Assembly
There is 1 Clock Set provided to be installed on the Front Wall. See Fort Guide for correct location. See below for
how to assemble and attach the Clock Set.
When installing you will need the following:
Base Clock, Clock Subset (includes minute and hour hands, clock adapter and clock screw), 2 (2717) Clock Blocks
and 4 x (S20) Wood Screws.
To assemble Clock insert the Clock Adapter from the back of the Base Clock, place the Hour Hand over the Clock
Adapter making sure they are lined up properly. Press the Minute Hand over the Hour Hand and connect with
Clock Screw.
Attach assembled Clock through panel and into each (2717) Clock Block with 4 (S20) Wood Screws.
Do not over tighten screws.
Side View
Clock
Adapter
2717
Panel
Wood Parts
2 x Clock Block
2717
Hour Hand
Clock
Screw
Minute Hand
Base Clock
Pre-drill each hole using a
1/8" drill bit.
4 x
Outside View
Base Clock
Inside View
Hardware
Wood Screw
S20
42
S20
2717
Other Parts
1 x Base Clock
1 x Clock Subset