Attach Exit End Assembly To Fort - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 38: Attach Exit End Assembly to Fort
Note: When installing Pan Bolts make sure to look
at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the
hexagonal recess. Keep all bolts loose until further
step.
A: Fit the Exit End Assembly to the last Elbow Assembly
by lining up the arrows on each assembly. Notice the
elbow orientation. (fig. 38.1)
B: Place 1 TNR2 Slide Clamp Ring to the top of the joined
Assemblies, rotate counter clockwise 1 hole location then
attach with 3 (PB1) Pan Bolts (with lock nut) as shown in
fig. 38.1.
Use Quadrex Driver as a guide pin for each hole
before inserting bolt.
C: Attach 1 TNR2 Slide Clamp Ring to the bottom of the
joined Assemblies using 3 (PB1) Pan Bolts (with lock nut)
as shown in fig. 38.2.
D: Connect the 2 TNR2 Slide Clamp Rings together in
2 spots using 1 (PB1) Pan Bolt (with lock nut) per hole.
Make sure seams and arrows line up and then tighten all
bolts. (fig. 38.3).
Fig. 38.3
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
PB1
LN1
8 x
Elbow
Assembly
Fig. 38.2
Bottom Slide Bolt Holes
Hardware
Pan Bolt (lock nut)
PB1
76
Fig. 38.1
Top Slide Bolt Holes
PB1
LN1
LN1
PB1
Other Parts
2 x TNR2 Slide Clamp Ring
Exit Elbow
Assembly