KidKraft CASTLEWOOD Installation And Operating Instructions Manual page 25

Step 3: Swing Wall Prep
Part 3
It is important to assemble the frame on a flat, smooth surface.
E: Attach (2630) SW Top to (2757) LT Post Assembly and (2758) RT Post Assembly with 2 (WB1) Wafer Bolts
(with flat washer) connecting to previously installed t-nuts. (fig. 3.5 and 3.6)
F: Attach (2768) Panel Floor to (2757) LT Post Assembly and (2758) RT Post Assembly with 2 (H9) Hex Bolts
(with lock washer and flat washer) connecting to previously installed t-nuts. (fig. 3.5).
G: Place 1 (2778) SW Ground MOD to each side of (2769) Panel BT Frame, notice the hole locations and attach
with 1 (H10) Hex Bolt (with lock washer and flat washer) per board connecting to previously installed t-nuts. (fig.
3.5 and 3.7).
H: Place 1 (2607) Diagonal under (2778) SW Ground MOD on the right hand side so the top sits against (2758)
RT Post Assembly and loosely attach with 1 (H10) Hex Bolt (with lock washer, flat washer and t-nut). (fig. 3.5
and 3.7).
Fig. 3.5
2630
Fig. 3.6
WB1
2778
Wood Parts
2 x SW Ground MOD
2778
1 x Diagonal
2607
WB1
x 2
2768
FW2
Fig. 3.7
2769
2 x
WB1
2 x
H9
3 x
H10
H9
x 2
2758
LW1
FW1
2757
Note which bolt holes are used
Hardware
Wafer Bolt (flat washer)
Hex Bolt (lock washer, flat washer)
Hex Bolt (lock washer, flat washer and 1 t-nut)
25
2607
LW1
2769
2778
H10
x 3
FW1
TN1
2778
2778