Disabling Remote Control - Barco ScreenPRO-II User Manual

3.
4.
5.
6.
7.
This completes the entire remote setup procedure. Please note:
•
•
ScreenPRO-II • User's Guide
Scroll to the Connection Type line:
~
For " External " source routing, select the router whose inputs you wish
to patch.
~
For " Internal " source routing, select the desired ScreenPRO-II unit
(e.g., SP1 or SP2 , etc.).
Tip If you are using multiple ScreenPRO-II units whose direct
(internal) router inputs are fed by DAs, select ALL SPs to
patch a selected input for all ScreenPRO-II units
simultaneously. For example, if the same VTR feeds input 1
on four ScreenPRO-II units (via DAs), selecting ALL SPs for
the Connection Type saves patching time, and conserves
input buttons on the Controller itself.
Scroll to the Router Input line and select the physical router input that you wish to
associate with the selected source number. The range depends on the number of
inputs defined in the Router Specification Menu .
Note The same router input can be chosen for different source
numbers.
{ }
Press ADD PATCH to finalize the new input patch.
(Optional) If required, press
case you need to start again, or re-define the patch.
Repeat from step 2 to assign all remaining inputs.
To set up your inputs (e.g., format, sizing, aspect, etc.), follow the normal
procedures for the Encore or ScreenPRO-II Controller.
To disable remote control, refer to the "
page 184.
Important Please review the "
Capabilities
differences between ScreenPRO-II and the Encore (or
ScreenPRO-II) Controller.
{ }
DELETE PATCH to delete the current patch — in

Disabling Remote Control

Remote Control Caveats and
" section on page 184 for important operational
aK==oÉãçíÉ=`çåíêçä
Using Remote Control
" section on
183