Installation - Barco ScreenPRO-II User Manual

3. Hardware Installation

Installation

fåëí~ää~íáçå
The figure below illustrates a block diagram of a basic ScreenPRO-II system. This diagram
can be used as reference in the following installation procedure.
Inputs
Analog Sources to Analog Inputs 1-8
HD/SD Sources to HD/SD Inputs 1-2
(HD Model Only)
DVI Sources to BG/DSK Inputs A-B
Genlock In
Genlock Loop (or terminate)
Figure 3-1. Block Diagram, Basic ScreenPRO-II System
You will need:
Table 3-3. Equipment List, Basic ScreenPRO-II System
Qty. Item
1 ScreenPRO-II Chassis
1 Video Projector
1 Analog Monitor
1 Analog or Digital Monitor
1 Ethernet Hub or Switch
2 Ethernet cables
2 Video cables
TBD Dedicated sources
Use the following steps to install ScreenPRO-II:
1.
2.
32
Program
Customer supplied
Preview (customer supplied)
Program (customer supplied)
Customer supplied (Optional, with Encore or ScreenPRO-II Controller)
Customer supplied (Optional, with Encore or ScreenPRO-II Controller)
Customer supplied (Genlock and Genlock Loop)
Analog video and/or DVI as required (customer supplied)
Follow the unpacking procedures as listed in the "
section on page 28.
As required, refer to the " Physical and Electrical Specifications
page 144 in Appendix A for electrical and mechanical details.
Preview
Projector
Ethernet
(Optional)
Ethernet Hub / Switch
Note
Unpacking and Inspection
ScreenPRO-II • User's Guide
Program Out 1 (Analog)
Preview Out
Program Out (Digital)
To Encore
Controller
"
" section on