Barco ScreenPRO-II User Manual page 184

aK==oÉãçíÉ=`çåíêçä
Using Remote Control
bñíÉêå~ä=bíÜÉêåÉí=oçìíÉê=`çåÑáÖìê~íáçå
The figure below illustrates the connections required for the following configuration:
•
•
•
MatrixPRO SDI Router
Ethernet
MatrixPRO Analog Router
Ethernet
Figure D-3. ScreenPRO-II Units using External Ethernet Controlled Routers
Use the following steps to connect ScreenPRO-II units as destinations, using external
Ethernet controlled routers:
1.
2.
172
Two (or more) ScreenPRO-II units are used as unique destinations.
One external Ethernet controlled router is used for analog source connections to
each ScreenPRO-II.
One external Ethernet controlled router is used for SDI source connections to
each ScreenPRO-II.
Outputs
Using a standard Ethernet cable, connect the Ethernet Port on the rear of the
ScreenPRO-II chassis to your system's Ethernet Hub (or Switch ). In Chapter 2,
refer to the " ScreenPRO-II Rear Panel
Ethernet port.
Note A completely "local" network is strongly recommended,
without IP connections to the outside world.
Repeat step 1 as required for each ScreenPRO-II chassis that you wish to use as
a destination.
Inputs ScreenPRO-II
" section on page 12 for the location of the
ScreenPRO-II • User's Guide
Encore Controller (SC or LC)
Ethernet
Hub / Switch