Input Patching - Barco ScreenPRO-II User Manual

aK==oÉãçíÉ=`çåíêçä
Using Remote Control
9.
10. Repeat from step 5 for all remaining outputs for the currently selected router.
11. Press
12. To select the next router whose outputs you wish to patch, repeat from step 3 .
Please continue with the "
fåéìí=m~íÅÜáåÖ
The input patch procedure enables you to associate specific router inputs with specific
source buttons on the Controller.
Use the following procedure to set up each router's input patching.
1.
B
A
C
K
Figure D-10. Input Patch Menu (sample)
2.
182
(Optional) If required, press
case you need to start again, or re-define the patch.
{ }
BACK to return to the Router Specification Menu .

Input Patching

Note This procedure is required for both " Internal " and " External "
source routing on your ScreenPRO-II units.
On the Encore or ScreenPRO-II Controller console, press SYSTEM > { INPUT
PATCH } to display the Input Patch Menu , a sample of which is shown below:
INPUT SOURCE PATCH
Source Number
Connection Type
Router Input
Note The Controller is pre-programmed with a series of default
input patches. For example, the first connected router will be
assigned the first series of inputs (e.g., 1 - 12 on the
Controller SC); the second router will be assigned the next
series of inputs (e.g., 13 - 24 ). You may elect to keep these
defaults, or "re-patch" as required.
Scroll to the Source Number line and select the source button on the Controller
that you want to patch.
{ }
DELETE PATCH to delete the current patch — in
" section on page 182.
1
MATRIXPRO1
1
ADD DELETE
PATCH PATCH
ScreenPRO-II • User's Guide
N
A
V
A
D
J