Barco ScreenPRO-II User Manual page 95

4. Menu Orientation
•
•
•
•
•
•
fåéìí=pçìêÅÉ=cìåÅíáçåë
At the bottom of the Input Source Adjustment Menu , three radio buttons enable you to
perform various input source adjustment functions.
•
•
•
•
ScreenPRO-II • User's Guide
V Position — indicates the input source's vertical position, relative to its default
vertical position ( 00 ) with no offset. Thus, the value -10 is 10 pixels below its
default position. Use the V Pos knob to move the source along the Y-Axis.
Move Rate — adjusts the rate (in 0.1 second increments) for programmed Key or
PIP movement, from keyframe to keyframe. To adjust, press the RATE radio
button and use the SIZE rotary knob.
Key Frame Effect — indicates the "motion type" that is used to move the Key or
PIP from point to point.
~
If no move is programmed, the display reads [N/A] .
~
If a move is programmed, the motion type is fixed as [Linear] .
Press { PIP } to jump to the PIP Adjustment Menu . Refer to the "
Menu Functions " section on page 68 for details.
Press { BORDER } to display the Border Menu . Refer to the "
section on page 70 for details.
Press { CROP } to display the Crop Menu . Refer to the "
page 71 for details.
Note To return the input source to its default size and aspect ratio,
press the RESET button in the Layer Functions Section .
No other parameters will be affected.
Press { TRACK } to lock H Size and V Size together. Regardless of the input
source's current aspect ratio, its size will adjust proportionally when the SIZE
rotary knob is used.
Press { H SIZE } to adjust only the horizontal size, leaving the vertical size alone.
In this way, you can stretch the input source horizontally.
Press { V SIZE } to adjust only the vertical size, leaving the horizontal size as is. In
this way, you can stretch the input source vertically.
Press { RATE } to adjust the move rate of the PIP or Key, from keyframe to
keyframe.
Input Source Adjustment Menu
PIP Adjustment
Border Menu "
Crop Menu " section on
83