Barco ScreenPRO-II User Manual page 42

3. Hardware Installation
Input Connection Chart
fåéìí=`çååÉÅíáçå=`Ü~êí=
The following Input Connection Chart is provided to assist with your input connections.
Please complete one chart for every ScreenPRO-II system, and make copies as required.
Please note the following important points:
•
•
•
•
•
•
•
Chart instructions:
•
•
•
•
Please complete the Input Connection Chart on the following page.
30
The mixer has eight analog input connections (scaled), and with the HD model,
two scaled HD/SD inputs. Additionally, two unscaled DVI connections are
provided for background and DSK sources.
There is a direct correspondence between the first eight buttons in the Source
Selection Bus and the eight numbered analog input connections. No additional
button-to-source configuration is required.
On the HD model, there is a direct correspondence between the two SDI buttons
in the Source Selection Bus and two numbered HD/SD input connections. No
additional button-to-source configuration is required.
The Analog inputs can also be used to connect composite, S-Video (Y/C) and
component video. In Chapter 2, refer to the "
page 14 for details.
To use two background sources, connect one to the Background A connector
and one to the Background B connector.
To use one background and one DSK source, connect the background to the
Background A connector and the DSK source to the Background B connector.
(Optional, for use with an Encore or ScreenPRO-II Controller) Two "router" modes
are available:
~
The "internal" mode is the standalone ScreenPRO-II mode, with sources
connected directly to inputs.
~
In the "external" mode, two analog outputs from a router (controlled by
the Encore or ScreenPRO-II console) are connected to ScreenPRO-II
SP analog inputs 1 and 2. In addition, two SDI outputs from a router
could be connected to SDI inputs 1 and 2.
Column 1 lists all input connectors.
Column 2 lists additional connector details:
~
Remember that the DVI connectors are digital only. There is no analog
component to them.
~
Be sure to check
later reference.
In Column 3, please list the physical source that supplies the input signal.
In Column 4, please list any notes or details pertaining to the source.
Analog Input Flexibility
the desired assignment of BG/DSK input B for your
[ ]
ScreenPRO-II • User's Guide
" section on