Barco ScreenPRO-II User Manual page 37

2. Hardware Orientation
Swap Z-order — press to change the visual priority (on Preview) of the two mixer layers.
The PIPs or keys remain at their current locations — only the priority changes.
Swap
Z-Order
In Chapter 6, refer to the "
Freeze — enables you to freeze a layer on both Program and Preview.
In Chapter 6, refer to the "
Freeze
Reset — press to reset the current effect (e.g., PIP, Key, crop, etc.) to a nominal default
value. You can think of this function as being "context sensitive" — as it resets only the
Reset
current effect, without affecting other modifications.
In Chapter 6, refer to the "
Move Setup — press to set up a "move" for a PIP or key, enabling you to choose the
move's start and end points.
Move
In Chapter 6, refer to the "
Setup
Move — press to pend a "move" for a PIP or key, enabling you to fly the PIP or key from
one location to another on the next auto transition.
Move
In Chapter 6, refer to the "
ScreenPRO-II • User's Guide
Example : If PIP B is visually on top of PIP A , press Swap Z-Order to place
PIP A on top of B .
Using Swap Z-Order
Using Freeze
Example : If you adjust a PIP's size, border and shadow, and wish to reset
only the border, navigate to the Border Menu and press Reset .
Using Reset " section on page 130 for details.
Using Move " section on page 132 for complete instructions.
Using Move " section on page 132 for complete instructions.
" section on page 129 for instructions.
" section on page 130 for instructions.
Front Panel Sections
25