Barco ScreenPRO-II User Manual page 122

5. System Setup
Setting up Backgrounds
8.
9.
10. To set up the next input, repeat the procedure from step 3 .
Please continue with the "
rëáåÖ=~=píáää=cê~ãÉ=~ë=~=_~ÅâÖêçìåÇ
This procedure enables you to capture a still frame image, and assign it as the "type" for
Background A or B . Please note:
•
•
Use the following steps to assign a captured still frame as the background "type."
1.
2.
3.
4.
Please continue with the "
110
For the two Crop settings:
~
If the input resolution matches the output resolution, or if the output
resolution is larger than the input resolution, the Crop settings will be
bracketed.
~
If the input resolution is larger than the output resolution, adjust the H
Offset and V Offset values to choose which portion of the input you want
to display.
~
If required, press { RESET } to reset the H and V offsets to 0 .
Press { SAVE } to save the selected source in the designated file.
Using a Still Frame as a Background
Capturing still frames into "temporary" memory can be performed either as a
setup procedure or during live production.
Once still frames are captured, during live production you can easily switch a
selected background between Matte, a DVI input and a Still Frame.
Important It is highly recommended that you save still frames into
"permanent" flash memory as a setup procedure — as this is
a very time-consuming step that locks the front panel of
ScreenPRO-II.
Ensure that your background input(s) are properly set up as DVI sources. These
background inputs are the sources of the still frames which you will capture.
Refer to the " Using a DVI Input as a Background or DSK
for background input setup details.
In Chapter 6, refer to the "
instructions on capturing still frames. Up to three frames can be captured into
temporary memory: FG_1 , FG_2 and FG_3 .
In the Layer Control Section , press the button for the background that you want
to set up ( BG A or BG B ). The button will blink and its associated BG Input
Setup Menu will appear.
Scroll to the Type line and select the desired still frame ( FG_1 , FG_2 and FG_3 ).
Setting up the DSK
Capturing Still Frames " section on page 137 for
" section on page 111.
ScreenPRO-II • User's Guide
" section on page 110.
" section on page 109