Barco ScreenPRO-II User Manual page 172

`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Ethernet Upgrade Method
5.
ScreenPRO-II
Figure C-4. Small Ethernet Network
6.
7.
8.
9.
160
h. Follow the prompts to install the upgrade package in the desired folder.
Note that at the conclusion of the procedure, a new path will be created
under Start > Programs > Barco Folsom .
Note Do not move or copy any files out of the target folder.
Configure a small network system consisting of a Hub, the ScreenPRO-II and
your PC (or laptop). Use the diagram below for reference.
Ethernet Hub / Switch
Note Do not connect this small network to any other network.
Connect the Serial 1 port on the back of the ScreenPRO-II to the COM 1 port on
your PC. In Chapter 2, refer to the "
page 12 for the location of the Serial 1 port.
Power-up the ScreenPRO-II and the Hub.
To assign a static IP address to the PC (or laptop), on the PC, click Start >
Settings > Control Panel to display the Control Panel Window.
Double-click the Network and Dial-up Connections icon to display the Network
and Dial-up Connections Window.
Laptop
ScreenPRO-II Rear Panel
ScreenPRO-II • User's Guide
" section on