Barco ScreenPRO-II User Manual page 32

2. Hardware Orientation
Front Panel Sections
pçìêÅÉ=pÉäÉÅíáçå=_ìë
The figure below illustrates the Source Selection Bus .
Source Selection
Program
1 2
Figure 2-4. Source Selection Bus
Each button represents an input that you can assign to a PIP or key.
•
•
Press a button in the section to assign the source to the blinking "mixer" button in the Layer
Control Section . When the button is lit and blinking, the source is on Preview, and is
active for manipulation as the PIP or key source on that layer.
•
1
•
•
•
20
~
The Middle and Bottom knobs are generally assigned to adjusting the
adjacent parameters, as labeled on the Touch Screen.
Note There is no Enter button. If you adjust a value with the
knobs, that function or value is immediately active in Preview.
3 4 5
Buttons 1 through 8 correspond to the eight analog inputs on the rear panel.
The two SDI buttons correspond to SDI inputs 1 and 2 on the rear panel. These
buttons are only labeled (and active) with the HD model of ScreenPRO-II.
When a source button lit solid, the source is on Preview — but it is not active for
manipulation.
When the Red LED above a source button is lit, the source is on Program.
Multiple sources can appear on Program and Preview simultaneously, but only
one button can be blinking and active for modification on Preview.
In Chapter 5, refer to the "
details on all source setup procedures.
6 7
Comprehensive Input Setup
ScreenPRO-II • User's Guide
SDI SDI
8
1 2
" section on page 104 for