Barco ScreenPRO-II User Manual page 189

açïåäç~ÇáåÖ=`çÇÉ
Once the Controller connects to the remote ScreenPRO-II unit(s), it automatically checks
the compatibility of the ScreenPRO-II code versions.
•
•
Use the following steps to download code from the Controller to all connected
ScreenPRO-II units:
1.
2.
B
A
C
K
Figure D-6. Download Code Results Menu (sample)
At the conclusion of the download procedure, each ScreenPRO-II unit is running the same
version of code as the Controller.
Please continue with the "
ScreenPRO-II • User's Guide
If the ScreenPRO-II code versions match the Controller's version, the System
Status Menu is shown, and you do not need to download code. Please continue
with the " Input Patching " section on page 182.
If the ScreenPRO-II versions are incompatible with the Controller, all buttons will
flash on the Controller console. The System Status Menu is shown with the
message " Please Upgrade ." Continue with the procedure below.
On the Encore or ScreenPRO-II Controller console, press SYSTEM > { SW VER }
to display the Software Version Menu .
Press { DOWNLOAD CODE } to begin the download process immediately. The
entire process takes several minutes to complete.
During the procedure, several "progress" messages will be shown. When
complete, the Download Code Results Menu appears:
Synchronize Code Results
Overall download complete.
Status Page 1 of 1:
2 SP(s) updated.
0 SP(s) failed.
0 SP(s) were current.
0 SP(s) checksum mismatch.
Total detected SP(s): 2
Destination Setup
aK==oÉãçíÉ=`çåíêçä
Using Remote Control
DETAILS
" section on page 178.
177