Barco ScreenPRO-II User Manual page 45

High-resolution seamless switcher
Hide thumbs Also See for ScreenPRO-II:
Table of Contents

Advertisement

3. Hardware Installation
3.
4.
5.
6.
7.
8.
9.
10. Power On — turn on power to all units.
ScreenPRO-II • User's Guide
As required, refer to the "
ScreenPRO-II Rear Panel
Chapter 2 for the locations of all connectors.
If you are rack mounting the ScreenPRO-II chassis, follow the rack mount
procedures as outlined in the "
Ethernet Connections (optional, for use with an Encore or ScreenPRO-II
Controller) — a completely "local" network connection is recommended, without
IP connections to the outside world.
a.
Using an Ethernet cable, connect the ScreenPRO-II's Ethernet port to a
Hub or Switch.
b.
Connect the Ethernet Hub or Switch to the Encore or ScreenPRO-II
Controller's Ethernet port.
Source Connections
a.
As an important prerequisite, complete the "
page 30 to streamline your source installation procedure.
b.
Using the information from the chart, connect the desired sources to the
analog and digital input connectors as required.
Output Connections
a.
One Analog Preview Output is provided. Connect this output to the
input of your analog Preview Monitor.
b.
Three Program Outputs are provided: One digital and two analog. Use
these outputs to connect your Program Monitor(s) and your projector.
For example:
Connect the Digital Program Output to the input of your projector.
Connect Analog Program Output 1 to the input of your main
program monitor.
Connect Analog Program Output 2 to an auxiliary or spare
program monitor.
Genlock Connections
a.
If you will be using synchronous video camera sources in your
production, use a BNC cable to connect a PAL or NTSC black burst or
composite sync signal to the Genlock In connector.
b.
If you are looping reference video to another chassis in your system,
connect a BNC cable from the Genlock Loop connector to the next
device's Genlock In connector.
c.
If this ScreenPRO-II chassis is the last device in a reference video chain,
do not make any connections to the Genlock Loop connector.
d.
Once the system has powered up, complete with Genlock Termination
procedure. Refer to the "
details.
Power Connection — connect an AC power cord to the AC Power Connector
on the rear of the ScreenPRO-II chassis, and then to AC outlets. Connect AC
Power cords (or AC adapters) to all peripheral equipment, such as Ethernet Hubs
and monitors. Please note:
~
Connect each unit only to a properly rated supply circuit.
~
Reliable grounding (earthing) of rack-mounted equipment should be
maintained.
" section on page 12 in
Rack-Mount Installation
" section on page 28.
Input Connection Chart
Genlock Termination
Installation
" on
" step on page 34 for
33

Advertisement

Table of Contents
loading

Table of Contents