Destination Setup - Barco ScreenPRO-II User Manual

aK==oÉãçíÉ=`çåíêçä
Using Remote Control
aÉëíáå~íáçå=pÉíìé
With code properly downloaded, the next procedure is to set up each ScreenPRO-II unit as
a unique Encore (or ScreenPRO-II Controller) destination.
Use the following steps to set up each ScreenPRO-II as a unique destination:
1.
B
A
C
K
Figure D-7. Destination Setup Menu (sample)
2.
3.
4.
5.
6.
7.
8.
At the conclusion of this procedure, each assigned destination can be selected on the
Encore or ScreenPRO-II Controller console.
Please continue as follows:
•
•
178
On the Encore or ScreenPRO-II Controller console (in the System Keypad ),
press SYSTEM > { DEST SETUP } to display the Destination Setup Menu .

DESTINATION SETUP

Destination
Type
SP to Add
SP to Remove
Routing Mode
SP assigned to Destination 1:
NONE
Scroll to the Destination line and select the destination number that you wish to
assign.
Scroll to the Type line and select Single Screen SP .
Scroll to the SP to Add line and select the ScreenPRO-II ID that you wish to add.
Press { ADD }.
(Optional) If you need to remove an ID from a selected destination, scroll to the
SP to Remove line and press { REMOVE }.
Scroll to the Routing Mode line, and select either Internal or External —
depending on the way that you want to configure your source routing.
Repeat from step 2 for each additional ScreenPRO-II destination that you want to
assign.
If you selected " External " routing, continue with the "
page 179.
If you selected " Internal " routing, please continue with the "
section on page 182.
1
Single Screen SP
1
N/A
[ N/A ]
REMOVE ADD
Router Setup
ScreenPRO-II • User's Guide
N
A
V
A
D
J
" section on
Input Patching "