Barco ScreenPRO-II User Manual page 24

2. Hardware Orientation
ScreenPRO-II Rear Panel
pÅêÉÉåmolJff=oÉ~ê=m~åÉä
The figure below illustrates the ScreenPRO-II rear panel:
1
Figure 2-1. ScreenPRO-II Rear Panel
1) SDI Inputs
2) Analog Inputs
3) Background/DSK Inputs
4) Program Outputs
Following are descriptions of each rear panel connector and section.
1)
2)
12
2
5) Preview Output
6) AC Connector
7) Genlock Connectors
8) Termination Switch
SDI Inputs
Two BNC connectors are provided for HD-SDI or SD-SDI inputs (or one of each).
These numbered inputs feed the system's internal 2 x 2 SDI router, and are
directly associated with the two SDI source buttons on the front panel's top row.
Note These connectors are populated only on the HD version of
the ScreenPRO-II.
These inputs will accept:
~
SDI (SMPTE 259M-C, NTSC or PAL)
~
HD-SDI (SMPTE 292M, HDTV).
In Chapter 5, refer to the "
input setup instructions.
Analog Inputs
Eight 15-pin D connectors are provided for Analog Inputs . These numbered
inputs feed the system's internal 8 x 2 analog router, and correspond directly to
the eight analog source buttons on the front panel.
7 8
3 4
9)
10)
Comprehensive Input Setup
ScreenPRO-II • User's Guide
9 10
5 6
Serial Ports
Ethernet Port
" section on page 104 for