Barco ScreenPRO-II User Manual page 175

19. To connect to the ScreenPRO-II serial port:
20. In the terminal window, ensure that the # prompt is displayed, then type:
21. In the terminal window, type:
22. On the PC, click Start > Programs > Barco Folsom > ScreenPRO-II Software >
Figure C-8. Flash Loader Utility
ScreenPRO-II • User's Guide
a. Click Start > Programs > Accessories > Communications >
HyperTerminal to launch the HyperTerminal application.
b. In the Connection Description dialog, enter a connection name,
choose an icon, and click OK .
c. In the Connect To dialog, click the Connect using pull-down menu, and
choose COM 1 .
d. Click OK to display the COM 1 Properties dialog.
e. Select the following settings:
• Baud Rate = 115200
• Data Bits = 8
• Parity = NONE
• Stop Bits = 1
LOADR
.... and wait a few seconds for the > prompt.
DHCP 0
You might have to wait 10 seconds, until it binds to 192.168.0.10 .
ScreenPRO-II Flash Loader to launch the Flash Loader utility, as shown below.
`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Ethernet Upgrade Method
163