Quick Setup And Operations - Barco PDS User Manual

4. Operation

Quick Setup and Operations

6.
7.
8.
9.
10. Select and adjust inputs — As required, select an input, and perform the
11. Save input configuration — After completing all adjustments for an input, save
12. Repeat for each input — repeat steps 10 and 11 for each input that you have
13. Adjust system parameters — As required, adjust all desired system parameters
14. Save system configuration — After completing all system adjustments, save the
15. (Optional) Remote Control — To control the PDS remotely, ensure that Ethernet
16. Ready to roll — With all output, input and system configurations saved, press the
26
Launch GUI — (Optional) If you want to run the system from the web-based GUI,
ensure that Ethernet is connected between your PC and the PDS, then launch the
GUI. (Chapter 5, "GUI Operations," page 85.)
Set output format — Set the desired output resolution and frame rate. (This
chapter, "Output Format," page 50.)
Enable test pattern — Turn on the desired test pattern, verify that you have an
image, and make the necessary adjustments. When complete, turn off the test
pattern. (This chapter, "Test
Save output configuration — After completing all output adjustments, save the
output configuration. (This chapter,
necessary adjustments. (This chapter,
the input configuration. (This chapter,
connected to the PDS.
such as transition time, display brightness, and all user preferences. (This
chapter, "Trans Time," page 58 and
system configuration. (This chapter,
or Serial communications are connected, then establish communications and
issue commands. (Appendix B,
desired input button, and press TAKE.
For advanced system operations, specific system "tweaks"
Note
and operating descriptions on every feature, please start with
the "Quick Function
select the function that you wish to perform.
Pattern," page 50.)
"Save Config," page 52.)
"Input Menu," page 36.)
"Save Config," page 46.)
"System Menu," page 63.)
"Save System State," page 72.)
"Remote Control," page 113.)
Reference" section on page 30, and
PDS • User's Guide