Setup (Program) - GE Multilin EPM 2000 Series Instruction Manual

2.2. Setup (Program)

The Meter must be Set (programmed/configured) to match the application settings, before
use. Otherwise, the readings will be wrong. All the Setup values can be re-programmed at any
time, upon entering "SET" However, the settings: Sys (Star/wye or Delta), Vpri, Vsec, Apri,
Asec critically determine the scaling of measured readings. While the scaling may be used to
tune out Instrument Transformer errors, wrong settings will upset the readings of running
systems. It is the user's responsibility to ensure that only qualified personnel correctly Set-up
the Meter.
Action
From the "RMS" or "INTG"
page, go Up
Then go Left .
"Code y" is displayed. "y"
blinks.
To proceed with Code Entry:
The code is Factory Set to
1000. Press to enter each
digit. Three times totally.
Press to decrement "2".
Press to enter the Main
Menu.
Now press
Again press
Press to get into "SET"
Once you're done, re-trace
your path: and .
Remember "Save Y"
GE Multilin
Display
Prog
"Code y " The meter is about to enter the Main Menu. "y" blinks.
To proceed with Code Entry, we need to enter the Main
Menu.
•
Go Left
Or, to abort and re-enter RMS:
•
Press .
Or, to only view setup, (no edit):
•
Press or
•
Press to enter Main Menu.
•
"Fail" is flashed, then "run" is displayed.
"000 0" The blinking digit indicates the cursor.
"2 000" We have now entered the Units, Tens and Hundreds digits.
The Thousands digit needs to be changed from 2 to 1.
" 1 000" Now the Code of 1000 is almost in.
" 0000" Notice that a "0" quickly hides each code-digit you enter.
"run" indicates a successful entry into the Main Menu.
"Pass" Congratulations!
"run"
If you were not successful, don't despair; you can have
Or, another go from the top of this Table! Briefly switching off
"Fail" the Meter will easily return you to the RMS page, the starting
point.
"CLR"
"SET" You are at the Setup page.
"2000" You've now entered the Setup Menu. The first two entries are
the Model Number and firmware version for easy
identification.
Go to see other Settings.
Go to see and change their values.
"run" You're now back to the top of the Main Menu. Go
see RMS. You can now go
pages.
Sub Meters
Remarks
.
to toggle "y" to "n".
or to view all the display
. You'll
20