Pitch - Intellijel Metropolix Manual

PITCH
Press EDIT + PITCH to access the per-stage PITCH override feature. This feature overrides, on a
stage-by stage basis, the track's PITCH output. To edit a Stage's PITCH override, press the Stage
button corresponding to the Stage you wish to edit.
There are two main parameters accessible by the button:
● PITCH OVERRIDE : Turning the encoder sets the note value sent to the track's PITCH output
each time the stage is played. You can enter any note (in the current scale) between 'C0' and
'C5.' If you turn the encoder fully counterclockwise, you'll enter a value of '--', which means the
stage does not contain a pitch override.
Keep in mind that the actual note being sent to the PITCH output can still vary from this setting if
you change the current SCALE, modulate the track's pitch, or use cumulative transposition
(ACCUM).
● SYNC : Sets the PITCH OVERRIDE to the current PITCH SLIDER position(s), which is an
alternative to dialing it in with the encoder. You can match the note on a single stage, or you can
match all notes on all stages. Specifically:
○ Push the encoder to set the current stage's PITCH OVERRIDE to the PITCH SLIDER'S
position at that stage.
○ Hold ALT and push the encoder to set all eight stage's PITCH OVERRIDE values to their
corresponding PITCH SLIDER positions.
Metropolix Manual 72