Transport Buttons; Run; Reset - Intellijel Metropolix Manual

TRANSPORT BUTTONS
(SECTION 5)
RUN
This button toggles between starting and stopping the sequencer. If the sequencer is not playing,
press the RUN button to start it playing in sync with the next pulse (or immediately if the pulse
happens at the same time). If a sequencer is playing, press the RUN button to stop it immediately.
When the sequencer is stopped, the gate outputs return to 0V.
The RUN button (and the corresponding RESET jack, if configured as a RUN jack in the
SETUP MENU ) will simultaneously start/stop playback of all three Metropolix tracks ( TRK 1 , TRK 2
and MOD ). You can, however, mute and unmute individual tracks (and even individual MOD Lanes),
by holding the LOOPY button while pressing the TRACK button or MOD Lane button that you want
muted. For more information, see
NOTE 1: In order to run, Metropolix needs a clock, either internally generated or externally supplied.
See the CLK section, later in this manual, to learn about the different ways to clock Metropolix.
RESET
This button manually resets the sequencer. The reset is synchronized to the first clock pulse after
you press the RESET button. When the sequencer is reset, the stage position returns to its original
starting stage and the
The RESET button (and the corresponding RESET jack, if configured as a RESET jack in the
SETUP MENU ) simultaneously resets all Metropolix tracks and MOD Lanes.
NOTE: To reset only a single Track (or all MOD Lanes), hold-down the desired button ( TRK 1 ,
TRK 2 or MOD ) while pressing the RESET button.
Muting Tracks and MOD Lanes
Cumulative Transpose
Metropolix Manual
.
counters are reset.
31