Inputs - Intellijel Metropolix Manual

INPUTS
[H] CLOCK IN - Patch an external clock source here. This input is used to synchronize Metropolix
playback to an external signal source, and requires that Metropolex be clocked externally
(which is enabled by pressing the SETUP button, and setting Clock to 'External').
NOTE: The Clock IN LED blinks in time with the clock division being applied to this incoming
external clock (as set with the Ext Clock Div parameter on the BPM screen, when
Clock = 'External'. The LED does not blink if the internal clock is used.
[I] RESET IN - By default, a trigger signal patched into this jack will reset the current sequence to
its beginning stage.
You can program individual tracks to ignore the RESET trigger by going to the
and setting the Global Reset option to 'Off.'
Using the SETUP MENU
RESET input). In this configuration, the sequence plays while the input gate signal is high, and
it doesn't play when the gate signal is low.
NOTE: The LED above the RESET jack flashes
[X] X IN - One of three AUX inputs for controlling Metropolix. Patch a control voltage source (-5V
to +5V) into this jack to modulate whichever sequencer parameter is assigned to that jack.
See AUX Input Settings
various parameters accomplish.
[Y] Y IN - A second AUX input for controlling Metropolix. It is functionally identical to the X IN .
[Z] Z IN - A third AUX input for controlling Metropolix. It, too, is functionally identical to X IN .
, you can reconfigure the jack to act as a RUN input (instead of a
to learn how to assign parameters to the X IN jack, and what those
Metropolix Manual
red each time the sequence resets.
TRACK MENU ,
13