Installation; Mounting Location; Mounting Options; Pole Mounting - Advanced Navigation GC-SER-LC Reference Manual

Gnss compass
Table of Contents

Advertisement

8

Installation

8.1

Mounting Location

Illustration 12: GNSS Compass ideal mounting location diagram
The GNSS Compass needs to be mounted in an area with a clear and unobstructed view of the
sky for best results. It should be mounted away from transmitting devices where possible.
Mounting the GNSS Compass close to structures and transmitting devices may degrade heading
performance due to interference.
8.2

Mounting options

The GNSS Compass can either be pole mounted, or surface mounted. See section 7.1 for details
8.2.1

Pole mounting

If pole mounting the unit, connection is via a single 1-14 UNS-2A thread.
8.2.2

Surface mounting

If mounting on a surface, use the 4 x M8 fixing holes as indicated in section 7.1. It is strongly
recommended to use the included shoulder washers to provide a small gap between the GNSS
compass and the mounting surface. This will help protect against warping or cracking of the unit on
slightly uneven surfaces. Note the shoulder washers will require a nominal 10mm hole in the
mounting surface as shown in illustration 13.
GNSS Compass Reference Manual
Page 32 of 85
Version 1.1
13/01/2021

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GC-SER-LC and is the answer not in the manual?

This manual is also suitable for:

Gc-poe-lcGc-poe-haGc-ser-haGnss

Table of Contents