Camera Module Installation - Sony Ericsson W600i Working Instruction, Mechanical

4.14.2

Camera Module Installation

If this part is being replaced, a new part should be used in the place of the old part when the
following steps are being performed.
Tools needed:
*
NOTE!
1. Obtain the camera module and make sure there is a
protective film over the camera lens.
2. Orient the camera module so that that tab located on
one side of the square portion of the camera module
corresponds to the notch in the camera socket.
3. Gently press the camera module into its camera
socket.
NOTE!
4. Visually check whether each of the four clips has
engaged before proceeding.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Style 2A ESD tweezers (Blunt tip)
If any clips were bent up away from the
walls of the camera socket during the
removal of the camera module, bend those
clips back down against the wall before
proceeding.
"Clicks" are normally heard when the clips
engage.
Pry tool
*
Step-by-Step Instructions
Working Instruction, Mechanical
64(128)