Inner Base Cover Installation - Sony Ericsson W600i Working Instruction, Mechanical

3.2.4

Inner Base Cover Installation

If the inner base cover is being replaced, a new part should be used in the place of the old part
when reassembling. Using a new inner base cover requires that a new Bluetooth antenna, a new
magnet, and a liquid intrusion indicator be installed on the new inner base cover. Refer to the
installation sections for the Bluetooth antenna, the magnet, and the liquid intrusion indicator for
instructions on how to install these components.
Tools needed:
•
NOTE!
1. Orient the inner base cover so that the outer surface of
the inner base cover is toward the flip and the curved
edge in the hinge cavity will align with the curved
edge of the hinge assembly.
2. Slide the two cable assemblies through the hole in the
inner base cover and position the inner base cover
down onto the hinge.
NOTE!
3. Place the two hinge braces on the inner surface of the
inner base cover as shown. An alignment peg
extending from the inner base cover should pass
through the corresponding alignment hole in each the
hinge braces.
NOTE!
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Torque screwdriver
Be careful not to damage the two cable
assemblies when installing the inner base
cover.
If the inner base cover is mated correctly with
the hinge assembly, then all four threaded
screw holes should be visible through the
four holes in the inner base cover and there
should not be any visible gap between where
the hinge and the screw holes in the inner
base cover come together.
The screw holes in each of the hinge braces
will line up with a screw holes in the hinge
when the braces are correctly positioned.
•
JCIS No. 0 bit
Step-by-Step Instructions
Working Instruction, Mechanical
42(128)