Antenna Assembly Installation - Sony Ericsson W600i Working Instruction, Mechanical

4.6.2

Antenna Assembly Installation

A new part must be used when the following steps are being performed.
Tools Needed:
•
1. Remove the protective covering from the portion of
the antenna assembly that adheres to the outer base
cover.
2. Position the antenna assembly over the antenna loop
portion of the outer base cover so that end of the
antenna with the flex film extending from it is
adjacent to the camera flash window in the outer
base cover.
3. While holding the new antenna over the outer base
cover, use a pair of style 2A tweezers and position
the flex film portion of the antenna around the two
alignment standoffs that are part of the ledge that the
antenna's flex film extension attaches too.
4. Once the antenna flex film extension is seated onto
its ledge, insert the antenna into the antenna loop
portion of the outer base cover.
5. Use the flat end of a pry tool to apply pressure over
the area where the antenna flex film mates to the
ledge in the outer base cover so that a good bond is
formed between the two.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Style 2A ESD tweezers (Blunt tip)
•
Step-by-Step Instructions
Working Instruction, Mechanical
Pry tool
49(128)