Keypad Switch Assembly Installation - Sony Ericsson W600i Working Instruction, Mechanical
Hide thumbs
Also See for W600i:
- User manual (93 pages) ,
- Quick manual (2 pages) ,
- Introduction manual (13 pages)
Table of Contents
Advertisement
4.12.2
Keypad Switch Assembly Installation
If this part is being replaced, a new part should be used in the place of the old part when the
following steps are being performed.
Tools needed:
1. Plug the keypad switch assembly's flex film
extension into its connection on the circuit board.
2. Position the keypad switch assembly over the circuit
board's exposed shield cans so that the lipped edges
of the switch assembly's metal plate catch on the
corresponding edges of the large shield can.
•
Perform sections 2.2.2 - 2.2.4 the Base Reassembly procedure.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
None
Step-by-Step Instructions
Working Instruction, Mechanical
59(128)
Advertisement
Table of Contents
