Battery Cover Installation - Sony Ericsson W600i Working Instruction, Mechanical

2.2.4

Battery Cover Installation

Tools needed:
If this part is being replaced, a new part should be used in the place of the old part when the
following steps are being performed.
NOTE!
1. Place the battery cover over the battery cavity so that
the extension off of the battery cover that is directly
below the camera flash is lined up with the
positioning mark on that edge of the battery cavity
and the side edges of the battery cover are flush
against the adjacent edges of the outer base cover.
2. Slide the battery cover towards the camera until the
battery cover snaps into place.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
None
Step-by-Step Instructions
The positioning mark, referred to in the next
step, consists of a line with an arrow
pointing towards it that is molded in the
edge of the outer base cover's battery
cavity.
Working Instruction, Mechanical
23(128)