Outer Base Cover Installation - Sony Ericsson W600i Working Instruction, Mechanical

2.2.2

Outer Base Cover Installation

If this part is being replaced, refer to the "Outer Base Cover" subsection under the "Parts
Replacement" portion of this document for detailed instructions on how to replace this part.
Tools needed:
•
•
1. Rotate the inner base cover relative to the flip
portion of the phone so that the phone is in the open
position as shown.
NOTE!
2. Orient the outer base cover so that it is perpendicular
to the flip assembly with the system connector end of
the outer base cover towards the inner base cover
and the battery cavity adjacent to the inner base
cover's keypad area.
NOTE!
NOTE!
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Torque screwdriver
Style 2A ESD tweezers (Blunt tip)
Verify that the two cables are not twisted
together.
Use one hand to hold the phone in this
orientation.
The cable assembly with the color mark
matches to the board connection that has the
large gold dot below it.
•
Step-by-Step Instructions
Working Instruction, Mechanical
Torx Plus size 5 bit
17(128)