Receiver Installation - Sony Ericsson W600i Working Instruction, Mechanical

4.38.2

Receiver Installation

Tools needed:
1. Orient the receiver relative to the display carrier's
receiver cavity so that the side of the receiver with the
dust gasket is away from the display carrier and
receiver springs point away from the LCD assembly.
2. From the top edge of the display carrier, slide the
receiver into the receiver cavity so that the side edges
of the receiver are under the ledges the run along each
side of the receiver cavity.
NOTE!
•
Perform sections 3.2.1 – 3.2.4 of the flip reassembly.
•
Perform sections 2.2.2 - 2.2.4 of the base reassembly.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
None
Step-by-Step Instructions
There should not be a significant gap between
the receiver and the LCD when the receiver
is completely slid into its slot.
Working Instruction, Mechanical
113(128)