Flip Reassembly; Display Carrier Assembly's Reassembly To Inner Flip Cover - Sony Ericsson W600i Working Instruction, Mechanical

3.2

Flip Reassembly

The reassembly of the flip portion of this product is broken into sections by the components that
need to be installed to perform the reassembly of the flip portion. The sections that make up the
"Flip Reassembly" procedure are arranged in the order that they must be performed to properly
reassemble the flip portion. If you have only performed a partial disassembly of the flip, perform
only the reassembly sections necessary.
3.2.1

Display Carrier Assembly's Reassembly to Inner Flip Cover

If the inner flip cover is being replaced, a new part should be used in the place of the old part
when performing the following procedure. Note that the power key, the camera key, the volume
key, and the music player key must be transferred from the old inner flip cover to the new one
before proceeding. For more details regarding the steps that must be performed on a new inner
flip cover before you can perform the following procedure, refer to the "Inner Flip Cover" section
under the "Part Replacement" portion of this document.
Tools needed:
•
•
1. Obtain the inner flip cover and verify that the power
key, the camera key, the volume key, and the music
player key are in their correct positions.
2. Orient the inner flip cover so that the inner surface is
upward and the side with the camera key is towards
you.
3. Rotate the inner flip cover so that the inner surface is
slightly towards you to help keep the camera key in
place.
4. Obtain the display carrier and verify that the keypad
lock key and the rubber plugs are in their correct
positions
5. If there is not a protective covering over the display,
place one there at this time.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Torque screwdriver
Style 2A ESD tweezers (Blunt tip)
•
Step-by-Step Instructions
Working Instruction, Mechanical
JCIS No. 0 bit
33(128)