Sony Ericsson W600i Working Instruction, Mechanical page 16

13. Insert the large tab portion of the system connector
cover into the opening between the system connector
the outer base cover.
14. Plug the system connector cover into the system
connector.
NOTE!
15. With the keypad switch assembly held directly over
the circuit board and the dome foil side of the
assembly away from the circuit board, plug the
keypad switch assembly's flex film into its
connection on the circuit board.
16. Then position the keypad switch assembly over the
exposed shield cans so that the lipped edges of the
keypad switch assembly's metal plate catch on the
corresponding edges of the large shield can.
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
If the system connector cover has been
installed correctly, the large tab portion of
the system connector cover can be seen
lying on top of the system connector.
Working Instruction, Mechanical
16(128)