Label Installation - Sony Ericsson W600i Working Instruction, Mechanical

4.17.2

Label Installation

Tools needed:
*
NOTE!
1. If a new label has not been created yet, then do so at
this time.
2. Use the four positioning marks on the circuit board
to place the label. Place the end of the label that
mounts adjacent to the battery connector first. Then
roll the rest of the label down onto the circuit board.
3. Once the label is correctly positioned, carefully
smooth the label into place.
NOTE!
•
Perform sections 2.2.3 – 2.2.4 of the Base Reassembly Procedure
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Pry tool
No more than two labels are allowed
stacked on top of each other in the battery
cavity. If there are already two labels
present, perform the label removal
procedure before continuing.
Do not apply pressure in the area indicated
due to the presence of a hole in the circuit
board at this location.
Step-by-Step Instructions
Working Instruction, Mechanical
70(128)