Sony Ericsson W600i Working Instruction, Mechanical page 30

NOTE!
NOTE!
4. Using the tip of a pair of style 2A tweezers, unplug
one of the cable connections from the display flex
film by pulling the cable connector alternately at the
two locations indicated in the direction shown.
5. Repeat the previous step to disconnect the other
cable connection from the display flex film.
6. Once the two cables have been unplugged, set the
hinge/cable assembly aside.
7. With one hand, hold the inner flip cover by its side
edges and press with one finger in the middle of the
hinge opening in the inner flip cover.
NOTE! Only a small amount of pressure should be
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Do not attempt to unplug the cable
assemblies by pulling on the cable
assembly's mass of cables.
There are two locations that the cable
connector must be alternately pulled at to
free the cable from its mating connector.
The pulling locations are labelled location 1
and location 2.
applied to the display carrier assembly. The
pressure is only being applied to keep the
latches on the inner base cover from re-latching
to the display carrier once they have been
unhooked.
Working Instruction, Mechanical
30(128)