Assembly And Disassembly; Assembly Sequence; Snapping The Head Station To The Din-Rail - WAGO 750 Series System Manual

Serie 750, 753

Assembly and Disassembly

6
DANGER
Do not work on products while energized!
High voltage can cause electric shock or burns!
• Disconnect all power sources from the product before performing any installation, re-
pair or maintenance.
Note
Note planning documents!
The structure of the node and installation in the system may only be carried out in accor-
dance with the planning documents provided by the system planner.
The following information must be provided:
• Information about the correct node structure
• Information about permissible mechanical, electrical and climatic ambient conditions
• Circuit diagrams
• Mounting position, cable types and lengths

6.1 Assembly Sequence

The components of the I/O system must be snapped directly onto a DIN-rail. Starting with
the head station, the I/O modules must be installed from left to right according to the
project design, in the nominal mounting position.

6.2 Snapping the Head Station to the DIN-Rail

1. Snap the head station onto the DIN-rail.
2. To attach the head station to the DIN-rail, use an operating tool to turn the DIN-rail
locking cam until the nose of the DIN-rail locking cam engages behind the DIN-rail.
System manual | Version: 3.0.2
Assembly and Disassembly
Figure 21: Locking the Head Station
43