MTS Systems Landmark 370 Series Operation page 59

3. If necessary, select a project.
It is common practice to keep all files in Project1. If you find this acceptable, at the Select
Project window, select Project1. Otherwise enter your own project name for the project.
Note: The Select Project window will not appear if you selected Project1 as the default
project when you installed the MTS TestSuite application.
4. If necessary, select a controller.
In the Controller Selection window, select the controller for the station that you are using.
Note: This window may not appear in all cases.
5. Select a configuration and parameter set.
Under normal circumstances, you would select a configuration file and parameter set
recommended by the experts in your lab. However, for this example test, select the Training
config.cfg configuration but do not click OK yet.
Parameter sets are found in the lower left corner of the Open Station window. For this
example test, select the Hard Specimen Tuning parameter set and click Open. A set of
windows may open based on the last user's window setup. Minimize any windows that appear
as you will be maximizing them as appropriate.
Landmark™ Test System Operation
Running the Example HCF Test
59